Filter
Top Products
452
EES4710BD 10 Slots L2/L3/L4 Chassis Switch
18.5.3.2.2 Passive interface configuration
Click “Passive interface configuration” to enter the configuration page. Equivalent to CLI command
18.4.2.2.11.
z Port: port list
z Passive interface configuration: sets up to receive OSPF packets only
z Cancel: cancels the setting.
z Reset: resets to default parameters
Example: Select port vlan1, select Passive interface configuration and click Apply button to
configure port vlan 1 as receiving OSPF packet only.
18.5.3.2.3 Sending packet cost configuration
Click “Sending packet cost configuration” to enter the configuration page.
z Vlan port: port list
z OSPF route cost configuration: specifies the cost needed for the OSPF protocol port.
Equivalent to CLI command 18.4.2.2.7
z Hello packet interval: specifies the interval time to send a hello packet on the ports. Equivalent
to CLI command 18.4.2.2.10
z Neighbor router invalid interval: specifies the invalid time length for neighboring Layer 3
switches. Equivalent to CLI command 18.4.2.2.8
z Sending link-state packet delay: sets up the value of Sending link-state packet delay on ports.
Equals to CLI command 18.4.2.2.14
z Sending link-state packet retransmit interval: specifies the Sending link-state packet retransmit
interval of the port with neighbor L3 switch. Equivalent to CLI command 18.4.2.2.13
z Reset: resets each column value to default in this page and this action will not change settings
z Apply: valid each column value. This action will change settings
z Default: resets to default settings. This action will change settings