Filter
Top Products
98
EES4710BD 10 Slots L2/L3/L4 Chassis Switch
Function: The switch sends an ICMP packet to remote devices to verify the connectivity between
the switch and remote devices.
Parameters: <ip-addr> is the target host IP address for ping, in decimal format.
Default: Sends 5 ICMP packets of 56 bytes each, timeout is 2 seconds.
Command mode: Admin Mode
Usage Guide: When the user types in the ping command and press Enter, the system will provide
an interactive mode for configuration, and the user can choose all the parameters for ping.
Example:
Example 1: Default parameter for ping.
Switch#ping 10.1.128.160
Type ^c to abort.
Sending 5 56-byte ICMP Echos to 10.1.128.160, timeout is 2 seconds.
...!!
Success rate is 40 percent (2/5), round-trip min/avg/max = 0/0/0 ms
As shown in the above example, the switch pings a device with an IP address of 10.1.128.160, three
ICMP request packets were sent without receiving corresponding reply packets (i.e., ping failed),
the last two packets were successfully replied, the successful rate was 40%. The switch represent
ping failure with a “.”, for unreachable targets; and represents ping success with “!” , for reachable
targets.
Switch#ping
protocol [IP]：
Target IP address：10.1.128.160
Repeat count [5]：100
Datagram size in byte [56]：1000
Timeout in milli-seconds [2000]：500
Extended commands [n]：n
Displayed information Explanation
Protocol [IP] Selects the ping for IP protocol
Target IP address Target IP address
Repeat count [5] Packet number, the default is 5
Datagram size in byte [56] ICMP packet size the default is 56 bytes
Timeout in milli-seconds [2000] Timeout (in milliseconds,) the default is 2
seconds
Extended commands [n] Whether to change the other options or not
5.2.2 Telnet
5.2.2.1 Introduction to Telnet