Filter
Top Products
72
EES4710BD 10 Slots L2/L3/L4 Chassis Switch
The corresponding prompt in Chinese is:
配置 Vlan1 接口
[0]: 配置 Vlan1 接口的 IP 地址
[1]: 配置 Vlan1 接口的状
[2]: 返回上一菜
序号:
Select “0” in the Vlan1 interface configuration menu and press Enter, the following screen will
appear:
Please input interface-Vlan1 IP address (A.B.C.D):
The corresponding prompt in Chinese is:
入 Vlan1 接口的 IP 地址(A.B.C.D):
When the user enters a valid IP address for Vlan1 interface and presses Enter, the following screen
will appear:
Please input interface-Vlan1 mask [255.255.255.0]:
The corresponding prompt in Chinese is:
入 Vlan1 接口的子网掩 [255.255.255.0]:
The system will show default mask of the Vlan1 interface to 255.255.255.0. The user can configure
the IP address and mask according to their own network conditions. After configuration, the menu
will return to the Vlan1 interface configuration section.
Select “1” in the Vlan1 interface configuration menu and press Enter, the following screen will
appear:
Open interface-Vlan1 for remote configuration ? (y/n) [y]:
The corresponding prompt in Chinese is:
是否打 Vlan1 的接口? (y/n) [y]:
Type “n” and press Enter to disable Vlan1 interface. Type “y” and press Enter, or just press Enter to
enable the Vlan1 interface. The Vlan1 interface configuration menu will then appear. Select “2” in
the Vlan1 interface configuration menu to return to the Setup main menu.
3.1.2.3 Telnet Server Configuration
Select “2” in the Setup main menu and press Enter to start configuration of the Telnet server, the
following will appear:
Configure telnet server