ADTRAN 4106 Plan A Network Card User Manual


 
Section 4 Network Turnup Procedure TRACER 4106/4206 System Manual
36 © 2004 ADTRAN, Inc. 612804206L2-1A
1. INTRODUCTION
This section discusses the installation process of the TRACER 4106/4206 system.
2. TOOLS REQUIRED
The tools required for the installation of the TRACER 4106/4206 are:
VT100 terminal or PC with terminal emulation software
RS-232 (DB-25 male for TRACER 4106/4206) cable for connecting to terminal
3. UNPACK AND INSPECT THE SYSTEM
Each TRACER 4106/4206 is shipped in its own cardboard shipping carton. Open each carton carefully and
avoid deep penetration into the carton with sharp objects.
After unpacking the unit, inspect it for possible shipping damage. If the equipment has been damaged in
transit, immediately file a claim with the carrier, then contact ADTRAN Customer Service (see Customer
Service, Product Support Information, and Training information in the front of this manual).
Contents of ADTRAN Shipment
Your ADTRAN shipment includes the following items:
TRACER 4106/4206 Unit
TRACER 4106/4206 Documentation CD
Four T1 Straight Through (RJ-48 to RJ-48) Cables
Changes or modifications not expressly approved by ADTRAN could void the user’s
authority to operate the equipment.
To prevent electrical shock, do not install equipment in a wet location or during a lightning
storm.
This system MUST be installed by qualifed service personnel in a Restricted Access
Location.