Filter
Top Products
Appendix B 141
Using the Telnet Utility
Using the Telnet Utility
Using the Telnet Utility
For backward compatibility with the E2050 LAN/GPIB Gateway, the Telnet
Utility functionality is provided with the E5810. However, E5810 Web Access
is the preferred method to configure the E5810.
Accessing the Telnet
Utility
To access the Telnet utility:
If you are on a Windows 2000 computer system, do the following:
From the Windows 2000 taskbar, select
Start | Programs | Accessories | Command Prompt.
The MS-DOS window opens.
From the Windows XP taskbar, select
Start | All Programs | Accessories|Command Prompt.
The MS-DOS window opens.
From the MS-DOS window, type telnet IP_address, where
IP_address is the IP address of the E5810, and then press
Enter.
When you are connected to the E5810 Telnet utility, you will see a
listing of main Telnet commands and current configuration values for
this E5810.
You may also need to adjust Local Echo in the Terminal Preferences
dialog box so the Telnet utility will properly display your typed input. To
do this:
From the menu at the top of the Telnet window, select
Terminal | Preferences. The
Terminal Preferences dialog
box is displayed.
Click the check box next to Local Echo to change it.
Click OK to close the Terminal Preferences dialog box.