Filter
Top Products
Chapter 2 55
Installing the E5810
Installing the E5810 on an Enterprise Network
Installing the E5810 on an Enterprise
Network
This step gives guidelines to install an E5810 on an Enterprise network.
Connecting the E5810 to the Network
This figure shows typical E5810 connections to an Enterprise network. You
can connect up to 14 GPIB instruments and one RS-232 instrument to each
E5810. Make connections from the E5810 to the network and to GPIB and/
or RS-232 instruments as required
.
NOTE
If your Enterprise network does not support Dynamic Host Configuration
Protocol (DHCP), you must first configure your E5810 on a Local network
as shown in “Configuring the E5810 on a Local Network” and then return
to this step to install the E5810 on the Enterprise network.
LAN
Tx
Ln
GP I B
RS232
!
POWER
GPIB
GPIB
GPIB
GPIB Instruments
Typically Hub or
Switch
OR
To Enterprise
Network Instrument
To RS-232
To AC Power
GPIB
LAN
E5810A