Filter
Top Products
144 Appendix B
Using the Telnet Utility
Telnet Commands for the E5810
Telnet Commands for the E5810
This table lists the Telnet commands you can use with the E5810. You
should use the Telnet configuration commands only if you are using the
Telnet configuration method to configure the E5810.You can see a summary
of all Telnet commands online by typing ? at any time within the Telnet utility.
NOTE
The Telnet utility is the ONLY way to clear syslog messages. When the
syslog message queue is full, new messages will not be accepted and
will not overwrite existing syslog messages. Use the
syslog-clear
command to clear syslog messages.
Command Description
help
View Help Information
?
View Available Commands
config
View Configured Settings
serial-num
View the Device Serial Number
version
View the Firmware Revision
hardware-addr
View the Ethernet (MAC) Address
dhcp <OFF|ON> Turn OFF or ON the use of DHCP
ip <ip address> View/Set the IP Address
subnet-mask <ip address> View/Set the Network Subnet Mask
gateway <ip address> View/Set the Gateway Address
dns-server <ip address> View/Set the DNS Server Address
hostname <string*35> View/Set the Internet Hostname
description <string*40> View/Set Device Description (UPnP Friendly Name)
upnp <OFF|ON> Turn OFF or ON the use of UPnP
lan-timeout <seconds> View/Set the LAN Timeout (Keepalive). 0 is Off.
io-timeout <seconds> View/Set the Server I/O Timeout. 0 is Off.