Filter
Top Products
LAN Interface Supplement 9-3
Quick Reference
EIA/TIA 568B Wiring
a. Either end of this cable can be used at the ana-
lyzer or LAN device. The connector names are a
convention useful during cable construction
only.
This cable can be used to cascade hubs or to make point-to-point
connections without a LAN hub.
NOTE A convenient way to make a cross-over adapter is to use two RJ-45 jacks
wired according to Table 9-2, above. Standard straight-through patch
cables can then be used from the analyzer to the adapter, and from the
adapter to other LAN devices. If you use a special-purpose adapter, you
will avoid having a cross-over cable mistaken for a standard,
straight-through patch cable.
NOTE Some commercially-available cross-over cables do not implement the
cross-over wiring required for your analyzer. Please refer to Table 9-2,
above, and verify all connections before using cables not made by Agilent
Technologies.
Not
Used
4 4 Not
Used
55
77
88
Cross-Over Wiring
a
Connector A Connector B
Signal
Name
RJ-45
Pin #
RJ-45
Pin #
Signal
Name