Filter
Top Products
Configuring Multicast Address Boundaries Quick Steps for Configuring Multicast Address Boundaries
OmniSwitch 6800/6850/9000 Advanced Routing Configuration Guide December 2007 page 5-3
3 Configure a multicast address boundary on the IP interface. Information must include the IP address
assigned at step 2, as well as a scoped multicast address and the corresponding subnet mask.
For example:
-> ip mroute-boundary vlan-2 239.120.0.0 255.255.0.0
Note. Optional. To verify the multicast boundary configuration, enter the show ip mroute-boundary
command. The display is similar to the one shown here:
-> show ip mroute-boundary
Interface Name Interface Address Boundary Address
--------------+-----------------+-------------------
vlan-2 178.14.1.43 239.120.0.0/16
For more information about this display, see the “Multicast Routing Commands” chapter in the
OmniSwitch CLI Reference Guide.