Filter
Top Products
Configuring PIM PIM Overview
OmniSwitch 6800/6850/9000 Advanced Routing Configuration Guide December 2007 page 7-13
RP Initiation of (S, G) Source-Specific Join Message
When the data rate at the Rendezvous Point (RP) exceeds the configured RP threshold value, the RP will
initiate a (S, G) source-specific Join message toward the source.
Note. To configure the RP threshold value, use the ip pim rp-threshold command.
Sender
Receiver
RP
DR
Legend
Source-Specific Join
DR
!
Encapsulated Data Exceeding RP Threshold
Source-Specific Join
Native Traffic