Filter
Top Products
Configuring OSPF Configuring OSPF
OmniSwitch 6800/6850/9000 Advanced Routing Configuration Guide December 2007 page 1-25
To optionally filter routes before redistribution, use the ip route-map command with a match parameter
to configure match criteria for incoming routes. For example,
-> ip route-map ospf-to-bgp sequence-number 10 match tag 8
The above command configures a match statement for the ospf-to-bgp route map to filter routes based on
their tag value. When this route map is applied, only OSPF routes with a tag value of eight are redistrib-
uted into the BGP network. All other routes with a different tag value are dropped.
Note. Configuring match statements is not required. However, if a route map does not contain any match
statements and the route map is applied using the ip redist command, the router redistributes all routes
into the network of the receiving protocol.
To modify route information before it is redistributed, use the ip route-map command with a set parame-
ter. For example,
-> ip route-map ospf-to-bgp sequence-number 10 set tag 5
The above command configures a set statement for the ospf-to-bgp route map that changes the route tag
value to five. Because this statement is part of the ospf-to-bgp route map, it is only applied to routes that
have an existing tag value equal to eight.
The following is a summary of the commands used in the above examples:
-> ip route-map ospf-to-bgp sequence-number 10 action permit
-> ip route-map ospf-to-bgp sequence-number 10 match tag 8
-> ip route-map ospf-to-bgp sequence-number 10 set tag 5
To verify a route map configuration, use the show ip route-map command:
-> show ip route-map
Route Maps: configured: 1 max: 200
Route Map: ospf-to-bgp Sequence Number: 10 Action permit
match tag 8
set tag 5