Filter
Top Products
Verifying PIM Configuration Configuring PIM
page 7-32 OmniSwitch 6800/6850/9000 Advanced Routing Configuration Guide December 2007
Verifying PIM Configuration
A summary of the show commands used for verifying PIM configuration is given here:
For more information about the displays that result from these commands, see the OmniSwitch CLI
Command Reference Guide.
show ip pim sparse Displays the status of the various global parameters for PIM-Sparse
Mode.
show ip pim dense Displays the status of the various global parameters for PIM-Dense
Mode.
show ip pim ssm group Displays the static configuration of multicast group mappings for PIM-
Source-Specific Multicast (SSM) mode.
show ip pim dense group Displays the static configuration of multicast group mappings for PIM-
Dense Mode (DM).
show ip pim neighbor Displays a list of active PIM neighbors.
show ip pim candidate-rp Displays the IP multicast groups for which the local router advertises
itself as a Candidate-RP.
show ip pim group-map Displays the PIM group mapping table.
show ip pim interface Displays detailed PIM settings for a specific interface. In general, it dis-
plays PIM settings for all the interfaces if no argument is specified.
show ip pim groute Displays all (*,G) states that the IPv4 PIM has.
show ip pim sgroute Displays all (S,G) states that the IPv4 PIM has.
show ip pim notifications Displays the configuration of the configured notification periods as well
as information on the events triggering the notifications.
show ip mroute Displays multicast routing information for IP datagrams sent by particu-
lar sources to the IP multicast groups known to this router.
show ip pim static-rp Displays the PIM Static RP table, which includes group address/mask,
the static Rendezvous Point (RP) address, and the current status of Static
RP configuration (i.e., enabled or disabled).
show ip pim bsr Displays information about the elected BSR.
show ip pim cbsr Displays the Candidate-BSR information that is used in the Bootstrap
messages.