Filter
Top Products
Chapter 2: Installation
74
Parity: None
Stop bits: 1
Flow control: None
Note
The port settings are for a DEC VT100 or ANSI terminal, or an
equivalent terminal emulator program.
Note
When you reset or power cycle the switch during a local
management session, you will see the following prompt: Press
<CTRL>B to go to Boot Prompt. This message is intended for
manufacturing purposes only. If you inadvertently display the boot
prompt (=>), type boot and press Return to start the switch.
4. Press Return.
You are prompted for a user name and password.
5. To view and configure all of the switch’s operating parameters, enter
the login name “manager”. The default password for manager access
is “friend”. To only view the parameter settings, enter the login name
“operator”. The default password for operator access is “operator”. The
user names and passwords are case-sensitive.
The Main Menu is displayed.
If you logged in with manager access, you can now fully manage the
switch using the management interface. For instructions, refer to the
AT-S62 Management Software User’s Guides. The guides are
available from the Allied Telesis web site at www.alliedtelesis.com and
on the CD included with the switch.