AT&T 7500 series Network Router User Manual


 
C-18 TRUNKING TERMS AND CAPABILITIES
_ ___________________________________________________________________________________________________________________________
_ ___________________________________________________________________________________________________________________________
_ ___________________________________________________________________________________________________________________________
_ ______________________________________________________________________________________
SWITCH A
FOR EACH "SWITCH A" TRUNKING OPTION (LISTED BELOW) — REFER TO THE
CORRESPONDING RECOMMENDED "SWITCH B" TRUNK OPTIONS (RIGHT FACING PAGE).
_ ______________________________________________________________________________________
GROUP/CALL TYPE DIREC- SUPERVISION SIGNALING
_ ____________________
TION
_ ________________________________________________________
GENERIC 2, GS LS RB E&M ISDN INCOMING OUTGOING TIMEOUT
SYSTEM 85, OR
DIMENSION PBX "ALERTING" "ADDRESSING" (NOTE 3)
_ ______________________________________________________________________________________
_ ______________________________________________________________________________________
12/APLT 2W D-9 DELAY-DIAL DIAL-TONE WITH 4-6 SEC
(Notes 1&2) WINK-START OR
DELAY-DIAL
_ ______________________________________________________________________________________
_ ______________________________________________________________________________________
13/APLT 2W D-10 WINK-START DIAL-TONE WITH 4-6 SEC
(Note 1) WINK-START OR
DELAY-DIAL
_ ______________________________________________________________________________________
_ ______________________________________________________________________________________
14/APLT 2W D-8 DELAY-DIAL DIAL-TONE WITH
IMMED-START
_ ______________________________________________________________________________________
_ ______________________________________________________________________________________
15/APLT 2W D-5 WINK-START DIAL-TONE WITH
IMMED-START
_ ______________________________________________________________________________________
_ ______________________________________________________________________________________
16/CO IN D-1
_ ________________________________________________________
19
_ ________________________________________________________
28 AUTO
_ ________________________________________________________
29 AUTO (NOTE 4)
_ ________________________________________________________
20 DMI-MOS (NOTE 5)
_ ______________________________________________________________________________________
_ ______________________________________________________________________________________
17/CO OUT D-1
_ ________________________________________________________
19
_ ________________________________________________________
28 IMMED-START
_ ________________________________________________________
29 WINK-START
_ ________________________________________________________
20 DMI-MOS (NOTE 5)
_ ______________________________________________________________________________________
Notes:
1. This trunk type is only applicable for APLT through dial applications (EPSCS applications).
2. Connections to an ETN-Main that is not equipped with FP8 issue 3 (yet providing Speed-Calling) should use APLT type-12
trunks (2-way delay /delay). Incoming calls can only reach the attendant via the network LDN(s) e.g., PBX access code plus a
2-, 3-, 4-, or 5-digit number. The single digit "0" will not work.
3. This type of trunk time-out indicates that if no signal is received and its expiration digits are automatically sent for outgoing type
calls, and the trunk is automatically connected for incoming calls. If no signal is received and time-out occurs, then digits are
automatically sent (for outgoing calls), or the trunk is automatically connected (for incoming calls).
4. This trunk type and optional signaling arrangement may be used to build a "Special Access" trunk group. Special Access refers
to a direct connection to a 4 ESS toll switch. A typical application for this trunk type/signaling arrangement is to support
MEGACOM800 DNIS.