Filter
Top Products
Chapter 6 Avaya P130 CLI
116 Avaya P130 User’s Guide
Set snmp trap Commands
Use the set snmp trap commands to add an entry into the SNMP trap receiver
table and to enable or disable the different SNMP traps for a specific receiver. First
add the rcvr_addr and then enable/disable the different traps for it.
The syntax for this command is:
set snmp trap <rcvr_addr>
set snmp trap <rcvr_addr> {enable|disable} {all|config|fault|...}
Example:
To enable SNMP ConfigChange traps to a specific manager:
P130-1# set snmp trap 192.122.173.42 enable config
SNMP config change traps enabled.
To enable all traps to a specific manager:
P130-1# set snmp trap 192.122.173.42 enable all
All SNMP traps enabled.
To disable SNMP config traps to a specific manager:
P130-1# set snmp trap 192.122.173.42 disable config
SNMP config traps disabled.
To add an entry in the SNMP trap receiver table with default:
P130-1# set snmp trap 192.122.173.42
SNMP trap receiver added.
enable Activate SNMP traps
disable Deactivate SNMP traps
all (Optional) Specify all trap types
config (Optional) Specify the ConfigChange trap from the TRAP-MIB.
fault (Optional) Specify the Fault trap from the TRAP-MIB.
rcvr_addr IP address or IP alias of the system to receive SNMP traps