Filter
Top Products
Chapter 6 Avaya P130 CLI
38 Avaya P130 User’s Guide
General Commands
Terminal Commands
Use the terminal width and terminal length commands to set the width and
length of the terminal display in characters.
The syntax for this command is:
terminal {width|length} [<characters>]
Clear screen Command
Use the clear screen command to clear the current terminal display.
The syntax for this command is:
clear screen
Ping Command
Use the ping command to send ICMP echo request packets to another node on the
network.
The syntax for this command is:
ping [host[number]]
Example:
To ping the IP number 149.49.48.1 ten times:
P130-N> ping 149.49.48.1 10
•IP Route Configuration Commands Page 97
•PPP Commands Page 99
• Radius Commands Page 105
• RMON Commands Page 108
• SNMP Commands Page 113
• Policy-based Networking Commands Page 119
host Host IP address/Internet address of route destination. If missing
then the last host IP is used.
number Number of packets to send. If missing then the last number is used