Filter
Top Products
Chapter 6 Avaya P130 CLI
70 Avaya P130 User’s Guide
Example:
To display LAG information data for port 10 on module 1:
P130-N> show port channel 1/10 info
Port Speed Duplex Vlan Port Trunk Vlan
Priority status Binding
------ ------ ------- ----- --------- -------- --------
1/10 10 half 1 0 off all
1/11 10 half 1 0 off all
Show port mirror Command
Use the show port mirror command to display mirroring information for the
switch.
The syntax for this command is:
show port mirror [<mod_num>[/<port_num>]]
Example:
P130-N> show port mirror
port mirroring
Mirroring both Rx and Tx packets from port 1/2 to port 1/4 is
enabled
Set port level Command
Use the set port level command to set the priority level of a port or range of
ports on the switching bus. Packets traveling through a port set at normal priority
should be served only after packets traveling through a port set at high priority are
served. Packets traveling with a 802.1p priority header are not affected by this
command.
The syntax for this command is:
set port level <mod_num>/<port_num> {[0-7]}
mod_num Module number
port_num Number of the port on the module
mod_num Module number
port_num Number of the port on the module