Chapter 6 Avaya P130 CLI
Avaya P130 User’s Guide 73
Set port speed Command
Use the set port speed command to configure the speed of a port or range of
ports.
In autonegotiation mode, the port's speed is determined by autonegotiation. You
cannot set the speed type to 10 or 100 when autonegotiation is enabled.
The syntax for this command is:
set port speed <mod_num/port_num><speed>
Example:
To configure port 2 on module 1 port speed to 10 Mbps:
P130-1# set port speed 1/2 10MB
Port 1/2 speed set to 10 Mbps.
Set port duplex Command
Use the set port duplex command to configure the duplex type of an Ethernet
or Fast Ethernet port or range of ports.
You can configure Ethernet and Fast Ethernet interfaces to either full duplex or half
duplex. The duplex status of a port in autonegotiation mode is determined by
autonegotiation. An error message is generated if you attempt to set the
transmission type of autonegotiation Fast Ethernet ports to half- or full-duplex
mode.
The syntax for this command is:
set port duplex <mod_num/port_num> {full | half}
mod_num Module number
port_num Number of the port on the module
<speed> Set port speed to 10, or 100 Mbps
mod_num Module number
port_num Number of the port on the module
full Keyword to specify full-duplex transmission
half Keyword to specify half-duplex transmission
