Filter
Top Products
3. Connections
Beside the standard RGB, component and sync signals, the extended mode of the 5 Cable input makes pro-
cessing of additional signals possible.
How to select a source on the 5 cable input ?
1. Press 1 on the RCU
Note: Another way for selecting this input is via the Menu
Component Video signals (PR/Y/PB)
Some interfaces use progressive output signals with a double line frequency of 32 kHz. The video decoder
used for the video signals is not appropriate for these signals since it can only handle 16 kHz signals. This
signalhas therefore tobe internally redirected, this isdone in the Source selection menu by selecting Data on
BNC’s instead of Componen t video and by selecting Pr/Y/Pb in the advanced settings of the Image f ile m
enu.
3.2.4 Composite Video Input
Composite video connection
A Composite video signal is often available on a yellow cinch connector of a Camera, VCR or DVD player, in this case you will need
an adapter cable cinch/BNC to connect to Video input of the RGB board.
Input specifications
The Composite video input section is made of 1BNC input terminal.
1.0 Vpp ± 3dB
75 Ω terminated
No loop through
Image 3-5
How to select a Composite Video Input ?
1. Press 3 on the RCU
Note: Another way for selecting this input is via th e Menu.
The projector allows the input of more composite video signals (up to 7 composite video signals).
"5 cable extended configuration", page 25
This note is not valid for the Pro version :
The Audio&Video optional layer(3) allows the use of an additional Video BNC input (referred to as Video2).
The selection of this optional input happens the same way as the standard input (key 3)
22 R5976491 IQ PRO G500 01/02/2007