Filter
Top Products
8. Image Settings
2. Press ENTER to activate.
A slider bar will be displayed. The actual viewport setting will indicated.
3. Use the ↑ or ↓ to set up the height of the viewport.
When set up the height of viewport, the image will be rescaled to the height of the LCD panel, see image 8-2 part F.
Viewport
Horizontal start
Width
Vertical start
Height
Total pixels
Automatic
Back
Menu 8-13
8.8.3 Automatic Viewport function
About the Automatic function
When the automatic viewport function is selected, the reproduced image returns to the active area of the input signal.
Image 8-3
Viewport automatic
A Actual viewport image
B Automatic viewport to active area
Automatic viewport detection only works correctly when the total pixels and total lines settings in the viewport
menu are more or less correct: The other settings (Horizontal start, horizontal size, vertical start, vertical size)
depend on these two settings. The software does not allow ’horizontal start’ + ’horizontal size’ to be larger
than ’total pixels’. The same goes for the vertical parameters. So in the rare case the input source causes the
wrong file to be selected, and that file happens to have a much too low setting for either of the two values ’total
pixels’ or ’total lines’, the automatic viewport function will not function correctly, because it will be limited to
the range in the ’total pixels’ and ’total lines’ values.
Steps to be taken
1. Select Automatic. (menu 8-14)
2. Press ENTER to activate.
48
R5976672 SOLARIS LC40 13/01/2005