1. Safety Instructions
General
• Always plug power cord into appliance before plugging into outlet.
• Do not allow anything to rest on the power cord. Do not locate this product where persons will walk on the cord.
• Always unplug appliance from electrical outlet before cleaning and servicing and when not in use. Never yank cord to pull plug
from outlet. Grasp plug and pull to disconnect.
• Do not operate appliance with a damaged cord or if the appliance has been dropped or damaged - until it has been examined
by a qualified serviceman.
• Position the cord so that it will not be tripped over, pulled, or contact hot surfaces.
• If an extension cord is necessary, a cord with a current rating at least equal to that of the appliance should be used. Cord rated
for less amperage than the appliance may overheat.
• Let appliance cool completely before storing. Remove cord from appliance when storing.
• Never push objects of any kind into this product through cabinet slots as they may touch dangerous voltage points or short out
parts that could result in a risk of fire or electrical shock.
• Never spill liquid of any kind on the product. Should any liquid or solid object fall into the cabinet, unplug the set an
dhaveit
checked by qualified service personnel before resuming operations.
• Lightning - For added protection for this video product during a lightning storm, or when it is left unattended and unused for
long periods of time, unplug it from the wall outlet. This will prevent damage to the projector due to lightning and AC power-line
surges.
1.3 Protection on Servicing
WARNING: Attempts to alter the factory-set internal controls or to change other control settings not specially
discussed in this manual can lead to permanent damage to the Unit and cancellation of the warranty
Servicing
Do not attempt to service the installed modules yourself, as opening or removing covers may expose you to dangerous voltage
potential and risk of electric shock! Refer all projector service to a qualified service center.
Call for service in the following conditions :
• When the power cord or plug is damaged or frayed.
• If liquid has been spilled into the modules.
• If the product has been exposed to rain or water.
• If the product does not operate normally when the operating instructions a
re followed. Adjust only those controls that are
covered by the operating instructions since improper adjustment of the other controls may result in damage and will often
require extensive work by a qualified technician to restore the product to normal operation;
• If the product has been dropped or the cabinet has been damaged;
• If the product exhibits a distinct change in performance, indicating a need for service.
Replacement Parts
When replacement parts are required, be sure the service technician has used original Barco replacement parts or authorized re-
placement parts which have the same characteristics as the Barco original part. Unauthorized substitutions may result in degraded
performance and reliability, fire, electric shock or other hazards. Unauthorized substitutions may void warranty.
Safety Check
Upon completion of any service or repairs to these modules, ask the service technician to perform safety checks to determine that
the modules are in proper operating condition.
Protection
Please do not disassemble or modify LCD module to avoid the possibility of electric shock, damage of electronic components, scratch
at display surface and invasion of foreign particles. In addition, such activity may result in fire accident due to burning of electronic
component. LCD module disassembled or modified by customer is out of warranty.
Please be careful in handling of display with broken glass. When the display glass breaks, please pay attention not to injure your
fingers. The display surface has the plastic film a
ttached, which prevents dispersion of glass pieces, however touching broken edge
will injure your fingers. Also Lamp (Cold Cathode Fluorescent Lamp) is made of glass, therefore please pay attention in the same
way.
Please do not touch the fluid flown out of broken display glass. If the fluid should stick to hand or clothes, wipe off with soap or
alcohol immediately and then wash it with water. If the fluid should get in eyes, wash eyes immediately with pure water for more
than 15 minutes and then consult the doctor.
Lamp contains mercury inside. Please follow regulations or rules established by local autonomy at its disposal.
4
R5976672 SOLARIS LC40 13/01/2005