Filter
Top Products
8. Image Settings
A message will be displayed while the Solaris LC40 examines the input signal : “Detection busy”.
The image jumps to the active area within the input signal.
Viewport
Horizontal start
Width
Vertical start
Height
Total pixels
Automatic
Back
Menu 8-14
8.8.4 Total pixels setup
About total number of pixels
Enter the total number of pixels in regard with the total number of pixels in your source. When the total number of pixels is not correct
(small differentiation), artifacts in the form of dark bars will be visible in the image. The more visible bars in the image, the more is
the differentiation from the correct value.
Image 8-4
Total number of pixels
A Image with wrong total number of pixels
B Correct adjusted image
How to set up
1. Select Total pixels. (menu 8-15)
2. Press ENTER to activate.
A slider bar will be displayed. The actual total pixel setting will inidcated.
3. Use the ↑ or ↓ to set up the total pixels.
Viewport
Horizontal start
Width
Vertical start
Height
Total pixels
Automatic
Back
Menu 8-15
8.9 Phase
About Phase adjustment
When displaying computer patterns or graphics (RGB or YUV signals) which are very detailed (tilting, vertical stripes, etc. ), jitter
in picture (mis-sampling) may occur, causing horizontal stripes in portions of the screen. Whe
n this jitter occurs, adjust ’Phase’ for
optimum image.
R5976672 SOLARIS LC40 13/01/2005
49