Filter
Top Products
12. Advanced Settings
When Automatic is selected, the Adjust option is grayed out.
Advanced Settings
Gamma
Color Temperature
Input Balance
Noise Reduction
Film mode detection [ON]
Video AGC
Display Settings
Installation
Service
Back
Menu 12-14
Noise Reduction
Adjust
[Manually]
Back
Menu 12-15
Adjusting the noise reduction manually.
1. Check first if the noise reduction is set to manually.
If yes, go to step 2
If no, Select first automatic and press ENTER to toggle to manually.
2. Select Adjust.
A slider bar will be displayed with the actual noise level reduction.
3. Use ↑ or ↓ to adjust the noise level to the desired value.
The higher the value, the higher the noise reduction.
12.6 Film mode detection
What can be done ?
Some sources like common DVD material are derived from cinema 24 Hz sources (2/2 or 3/2 pull down method).
The film mode detection insures that these converted signals are shown without artefacts.
This function may cause undesired effects on standard sources, therefore it can be disabled (OFF) at any time
2:2 pull-down
The process of transferring 24-frames/sec film format into video by repeating each frame (used for PAL DVD’s) as two
video fields. ( AD )
3:2 pull-down
Method used to map the 24 fps of film onto the 30 fps (60 fields) or 25 fps (50 fields), so that one film frame occupies
three video fields, the next two, etc. It means the two fields of every other video frame come from different film frames
making operations such as rotoscoping impossible, and requiring care in editing. Some sophisticated equipment can
unravel the 3:2 sequence to allow frame-by-frame treatment and subsequently re-compose 3:2. The 3:2 sequence
repeats every five video frames and four film frames, the latter identified as A-D. Only film frame A is fully on a video
frame and so exists at one time code only, making it the editable point of the video sequence.
How to switch the film mode
1. Select Advanced Settings .
2. Press ENTER to activate.
The Advanced Settings menu will be displayed. (menu 12-16)
3. Select Film mode detection.
4. Press ENTER to toggle between [on] and [off].
R5976672 SOLARIS LC40 13/01/2005
69