Filter
Top Products
13. Installation menu
13.6 RS232 baudrate
How to change the baudrate?
1. Press MENU to activate the Tool bar
2. Press → to select the Insta llation item
3. Press ↓ to Pull down the Installation menu
4. Use ↑ or ↓ to select RS232 baudrate (image 13-11)
5. Press → to pull down the menu
6. Use ↓ or ↑ to select the desired baudrate
7. Press ENTER
Image 13-11
13.7 Automatic startup
What can be done ?
The automatic startup allows immediate restart of the projector after a power failure (breakdown), i.e. without passing through the
standby state.
The projector restarts at power resume and recovers the previous settings (previous source,...).
This function can be disabled if undesired or inadequate for safety reasons, etc.
CAUTION: If the Automatic startup function is enabled one must be aware of the fact that it involves safety
precautions
Make sure that the projector (or the operators!) will n
ot be affected by altered environmental conditions when
restarting at power resume.
How to enable/disable the Automatic startup?
1. Press MENU to activate the Tool bar
2. Press → to select the Insta llation item
3. Press ↓ to Pull down the Installation menu
4. Use ↑ or ↓ to select Autom atic startup
5. Press → to pull down the menu
6. Use ↓ or ↑ to enable/disable the automatic startup
7. Press ENTER
120
R5976694 IQ PRO R500 01/02/2007