Filter
Top Products
4-2
Connections
5976135 BARCOSIM 6 21032000
COLORPHASE
SHARPN TINT BRIGHTN
STANDBY
ENTER
TEXT
EXIT
PAUSE
Lamp Run Time
When the total run time of the lamp is X-30 hours or more, the following warning message will be displayed for 1 minute. This warning
message will be repeated every 30 minutes. Press EXIT to remove the message before the minute is over.
Remaining
Lamp run time
20 h
<ENTER> to continue
WARNING
Lamp run time is X hours
Operating the lamp longer
than X hours may damage
the projector.
Please replace the lamp
Saving data, Please wait
To start image projection :
a. press the 'Stand by' button once on the local keypad or on the remote control. The projector mode indication lamp will be green.
b. press a digit button to select an input source. The projector mode indication lamp will be green.
When the total run time of the lamp is X hours or more, the following warning message, with the exact run time is displayed on the
screen.
Lamp run time is X hours. Operating the lamp longer than X hours may damage the projector. Please replace the lamp.
When OK (ENTER) is pressed to go on, the warning will be repeated every 30 min.
The total lifetime of the lamp for a safe operation is X hours max. Do not use it longer. Always replace with a same type of lamp. Call
a BARCO authorized service technician for lamp replacement.
Lamp Run Time Warning
Using a lamp for more than X hours is dangerous as the lamp could explode.
Switching to Stand-by.
When the projector is running and you want to go to stand-by, press the stand-by key for 2 seconds until the message 'Saving data,
please wait' is displayed. Do not press any longer on the standby key otherwise the projector will restart.