Filter
Top Products
5-3
Getting Started
5976135 BARCOREALITY SIM6 21032000
Remaining
Lamp run time
20 h
<ENTER> to continue
WARNING
Lamp run time is X hours
Operating the lamp longer
than X hours may damage
the projector.
Please replace the lamp
Saving data, Please wait
Lamp Run Time
When the total run time of the lamp is X-30 hours or more, the following warning message will be displayed for 1 minute. This warning
message will be repeated every 30 minutes. Press EXIT to remove the message before the minute is over.
When the total run time of the lamp is X hours or more, the following warning message, with the exact run time is displayed on the
screen.
Lamp run time is X hours. Operating the lamp longer than X hours may damage the projector. Please replace the lamp.
When OK (ENTER) is pressed to go on, the warning will be repeated every 30 min.
The total lifetime of the lamp for a safe operation is X hours max. Do not use it longer. Always replace with a same type of lamp. Call
a BARCO authorized service technician for lamp replacement.
Lamp Run Time Warning
Using a lamp for more than X hours is dangerous as the lamp could explode.
Switching to Stand-by.
When the projector is running and you want to go to stand-by, press the stand-by key for 2 seconds until the message 'Saving data,
please wait' is displayed. Do not press any longer on the standby key otherwise the projector will restart.
Switching Off
To switch off:
- First press STANDBY key for 2 seconds. When the message 'Saving data, please wait' is displayed, do not press any longer on
the standby key otherwise the projector will restart. Let cool down the projector at least 10 min.
- Switch off the projector with the power switch.
Switching to Stand-by Warning
When switching to standby, it is possible to restart within the first 5sec.. When not restarted within these first 5 sec.,
the projector waits for 1 min. to restart again. During this period the LED display will show a jumping square with a dash.
After one minute, two dashes will be displayed and the projector can restart.
Quick Set Up Adjustments
Quick Lens Adjustment
For a quick lens set up and image shift, press the Selection key (* key), to display inmediately the zoom/focus menu.
Only available for motorized lenses.
For a quick set-up, handle as follow :
A. Zoom/focus of the lens.
1 Press the Selection key.
The zoom/focus menu will be displayed.
2 Push the cursor key é or ê to zoom and ç and è to focus the image.
3 When finished, press EXIT key to return or ENTER to continue to the shift adjustment.