Filter
Top Products
4-8
Connections
5976135 BARCOSIM 6 21032000
RS232 Connection
RS232 in / RS232 out
To connect a Computer, e.g. IBM PC (or compatible), Apple Macintosh to the RS 232 input of the projector to allow communicate
between the computer and the projector.
SDI
SDO
S-VIDEO
VIDEO
COMPUTER
IEEE 1394
TRIG
MOUSE
MONITOR
RS232 IN RS232 OUT
AUDIO IN AUDIO IN AUDIO IN
AUDIO IN
COMM. PORT
RC
CB
A
R
GBH/CV
5
6
2
1
43
Applications :
a) remote control :
- easy adjustment of projector via IBM PC (or compatible) or MAC connection.
- allow storage of multiple projector configurations and set ups.
- wide range of control possibilities.
- address range from 0 to 255.
b) data communications :
- sending data to the projector or copying the data from the projector to a hard memory device (hard disc, floppy, etc.).
Set up of the Baud Rate for Communication with a Computer :
See
'Change Baudrate PC'
in chapter
'Service mode'
.
Communication port for communication with peripherals
Configurations of the port.
This port can be configured to accept PPM or RC5 coded signals.
To change the port configuration see 800 Peripherals in Chapter Installation.
Connecting a RCVDS 05 to the projector.
- Up to 20 inputs with the RCVDS 05 and 90 inputs when RCVDS's are linked via the expansion module.
- Serial communication with the projector.
- Remote control buttons on the RCVDS to control the projector (source selection and analog settings).
- The selected source number will be displayed on a 2 digit display and the selected input module will be indicated with a LED on
the rear.
For more information about the use of the RCVDS 05, consult the owner's manual of the RCVDS05.
TRIG Output
5 V output voltage to trigger an external device (max. 10mA).
This voltage is available when the projector is on.