Filter
Top Products
19
CHAPTER 2: Introduction
Panel Label Connector Description
Connect the ServSwitch’s power-supply cord
here. This is not a keyboard input. Power
transformers are available for 110 VAC or
230 VAC. Both have center-tapped output of
17 VAC at 700mA.
5-pin
DIN F
POWER
If you connect a more distant computer or
terminal to this RS-232 serial port, you’ll be able
to send switching commands to the ServSwitch
from a secondary location. You would also
connect a computer to this port to upgrade the
Switch’s firmware. Refer to Section 4.4.
RJ-12 FRS-232
Connect the shared monitor, keyboard, and
mouse to this port using an “MKM Adapter
Cable.” At the ServSwitch end, this cable has a
DB25 male connector; at the other ends, it has
appropriate connectors to plug into your
monitor, keyboard, and mouse cables. Only one
MKM Adapter Cable is needed. See Section 2.5.
DB25 FMONITOR/
KEYBOARD/
MOUSE
For each submaster you plan to connect, you
must have an Expansion Cable; you must have
an Adapter Cable for each CPU you plan to
connect. See Section 2.5.
NOTE
The mini-model chassis has 4 CPU N
connector slots. The full-size chassis
has 16 of these slots. The extra
connector slots in the chassis of the
2-port mini and the 4-, 8-, and 12-port
full-size models are left blank, but are
protected by material mounted inside
the chassis.
DB25 FCPU N
(continued)