Filter
Top Products
113
F
OR
F
IBEROPTIC
C
ABLING
:
The Autotest Results screen will be displayed. The name of the Autotest, the cable
that was used to run the test, and the overall test result ( PASS or
FAIL) for both fibers are shown.
, , or (Loopback) is displayed to inform you what
method was used to set the reference. See Chapter 8, Fiberoptic Reference, for
further information.
When dual fiber was measured, arrows at the top of the screen point out the
direction of the light. The arrows also indicate the fiber that the (PASS) or
(FAIL) result is for.
The number of connectors and splices is shown at the bottom of the screen if
the Autotest loss criteria is formula-based. (See Appendix C for further
information.)
Press or to toggle between the results for OMNIScanner and
OMNIRemote.
Press ESC to return to the Project Name screen.
Press ESC to return to the Results screen.
7.3 Results Stored on a MultiMedia Card
OMNIScanner2 allows you to view results that are stored on the MMC.
Internally stored results are identified by a light Project folder.
CHAPTER 7: Results