Filter
Top Products
5-4 Setting Printing Tab Options
Setting Printing Tab Options
The Printing options tab is shown in Figure 5-1. You specify your system’s print
job defaults on this tab. The options are:
Supply saver Turns basic multiple-up printing ON or OFF. The
default setting is OFF. The Supply saver printing feature
saves supplies by arranging labels of the same size
together in the print queue.This saves tape because it
stacks labels that are smaller than the full width of the
tape so that the full width of the tape is used, and it saves
ribbon because it groups labels to print within a set of
ribbon panels. (The sample in Figure 11-10 on page 11-
20 illustrates a print job with five separate labels that
have been stacked by supply saver.)
In addition, if you have the Color & Cut system, when
Supply saver is ON, your system cuts out each label
individually. See Checking Supplies on page 12-10.
Recalibrate
Columns during
Cutting
Applicable only when cutting out multiple labels using
the Supply saver option. If you select Recalibrate
Columns during Cutting, the printer rewinds the tape to
the leading edge after each column of labels is cut out,
making the cut output more accurate.
If Supply saver is not selected, this option is not
available.