Filter
Top Products
USER’S GUIDE
2–6
English: HS3 User’s Guide, Chapter 2
Loading Paper into the Feeder
To load paper into the feeder, follow these steps.
1. Pull the cover of the sheet feeder forward.
2. Load paper into the sheet feeder with the printing surface face up.
☛ Caution
The feeder can hold up to 200 sheets of 80 g/m
2
(20 lb.) plain paper. If you
load too many sheets, paper jams could occur.
Make sure that the paper is stacked below the ▼ mark.
If there is still some paper left in the feeder, you must first remove it, put it
together with the new paper and then insert the stack into the feeder.
✒ Note
When you load envelopes in the feeder, make sure they are inserte
d
in the
direction shown below. The Stamp corner at the lower right hand corner of
the envelope should face the front of the printer.
The first feeder can hold up to 10 sheets of envelopes and you can load an
envelope sheet by sheet into a manual feed slot.
Set the head gap lever to the ‘Envelope and Transparency’ position.
Fig. 2-4 Loading Envelopes in the Feeder