Filter
Top Products
USER’S GUIDE
4–6
English: CS3 User’s Guide, Chapter 4
Reset and Hex Dump print mode
The printer has the following Reset and Hex Dump print modes.
1. Keep the
FF/Cont
button depressed until all four LEDs light. Then, release
the button.
The printer enters the reset/hex dump mode. The
Alarm
LED blinks to
indicate that the first choice, User Reset, is selected. See the table below.
2. Press the
Online
button to select another choice.
Every time you press the button, the blinking LED changes to indicate
another choice. See the table below.
3. Press the
FF/Cont
button to perform the selected choice.
LED Choice Function
Alarm
User Reset The printer is restored to the user default
settings without clearing permanent fonts and
macros.
Manual
Factory Reset The printer is restored to the factory settings
and permanent fonts and macros are cleared.
Data
Hex Dump
print
The printer can print data as hexadecimal
values, so that you can check data errors and
problems. To exit from this mode, press the
Reset button or turn the printer off.
4. The printer returns to the ready status after printing