Filter
Top Products
CHAPTER 4 CONTROL PANEL
4–5
English: CS3 User’s Guide, Chapter 4
Test Print Mode
The printer has the following test print modes.
1. Keep the
Online
button depressed until all four LEDs light. Then, release
the button.
The printer enters test print mode. The
Alarm
LED blinks to indicate that
the first choice, Print Config, is selected. See the table below.
2. Press the
Online
button to select another test.
Every time you press the button, the blinking LED changes to select another
choice. See the table below.
3. Press the
FF/Cont
button to perform the selected choice.
LED Choice Function
Alarm
Print Config The printer prints the current printer settings.
Manual
Print Fonts I The printer prints a list of the printer resident
fonts.
Data
Print Fonts P The printer prints a list of the permanent
download fonts.
Ready
Test Print The printer prints a test page.
4. The printer returns to the ready status after printing.
✒ Note
Press the buttons gently. Do not press with too much force or hold the buttons
down for a long time. If you do the operation might now start.