Filter
Top Products
20
CHAPTER TWO
Do not connect a TAD elsewhere on the same phone line—your MFC and
TAD will both try to control the line.
Connections
The external TAD must be plugged into the left side of the MFC in the jack
labeled EXT. Your MFC cannot work properly if you plug the TAD into a wall
jack.
NO!
TAD TAD
LINE
EXT.
YES!
1
Plug the telephone line cord from the wall jack into the left side of the
MFC, in the jack labeled LINE.
2
Plug the telephone line cord from your TAD into the left side of the
MFC, in the jack labeled EXT. (Make sure this cord is connected to the
TAD at the TAD’s telephone line jack, and not its telephone set jack.)
3
Set your external TAD to four rings or less. (The MFC’s Ring Delay
setting does not apply).
4
Record the outgoing message (see below).
5
Set the TAD to answer calls.
6
For MFC 6650MC only, set Message Storage (
Function
,
1
,
8
,
1
) to
VOICE:EXT.
7
Set the Answer Mode to MSG CTR (for MFC 6650MC only). Set the
Answer Mode to TAD (for MFC 4350, MFC 4650 and MFC 7750 only).
Press
Mode
until both FAX and FAX/TEL lights are on.