Filter
Top Products
21
On a Macintosh Computer
The Mac version of the software is for a Macintosh with an English operating system. If the
software is installed on a Macintosh with an operating system in a different language, the soft-
ware may not run properly.
BEFORE INSTALLATION
Check that your system configuration meets the following requirements.
Computer:
Macintosh with Power PC processor
Operating system:
Mac OS 8.6 to 9.X or OS X 10.1 to 10.2.4
Hard disk free space:
At least 20 MB (100 MB for a full installation)
☞
Up to 100 MB of hard disk free space may be needed when printing long labels or large
amounts of data.
Memory:
At least 32 MB
USB port
(installed as standard equipment)
CD-ROM drive
INSTALLING THE P-TOUCH EDITOR 3.2 SOFTWARE
The P-touch Editor 3.2 software includes a variety of more complex functions for printing bar
codes and images, enabling you to design just about any label you can imagine. Install the
P-touch Editor 3.2 software onto a Macintosh as described below.
1
With the P-touch and the Macintosh turned off, connect the P-touch to the computer
using the enclosed USB interface cable as described on page 6.
Be sure to leave the
P-touch turned off.
2
Turn on the Macintosh.
3
Insert the enclosed CD-ROM into the computer’s CD-ROM drive.
4
Double-click the Mac OS 9 folder to open it.
5
Double-click the P-touch Editor 3.2 folder to
open it.
With Mac OS 8.6 to 9.X: