Filter
Top Products
10 - 6 BANYAN VINES NETWORK CONFIGURATION
YL4US_FAX2800MFC4800-FM5.5
Print Server Configuration Using the Print Server
Console
As an alternative to BRAdmin, you may use the print server console
to configure the print server. The steps are as follows:
1
Connect to the print server console using TELNET, NCP,
BRCONFIG Execute some or all of the commands detailed
below (you must minimally enter the StreetTalk login name of
the print server and associate one of the print server services
with the StreetTalk name of a print queue).
SET BAnyan LOgin loginname
Sets the StreetTalk login name of print server.
SET BAnyan PAssword password
Sets the login password of print server. The password (if any) must
match the password you specified in step 3 of the File Server User
Console section.
SET SERVIce service STreettalk queuename
Enables the Banyan protocol on the specified Brother print server
service and associates this service with the StreetTalk name of a
given print queue on the VINES file server. Type SHOW SERVICE to
see a list of the available services (if in doubt, use BINARY_P1).
SET BAnyan HOp nn
Sets number of hops between the Brother print server and the
Banyan file server. The default value is 2, which is adequate for most
sites, but you will need to change this value if the file server is more
than two hops away from the print server.
When you have finished entering commands, type EXIT to exit the
remote console and cause the commands to take effect.