Filter
Top Products
Chapter 2 Avaya P460 CLI Commands
98 Avaya P460 Reference Guide
ports.
In auto-negotiation mode, the port's speed is determined by auto negotiation. An
error message is generated if you attempt to set the speed when auto negotiation is
enabled
The syntax for this command is:
set port speed <module>/<port> <10MB|100MB|1GB>
Example:
To configure port 1 on module 4 to 100 Mbps
set port static-vlan
User level: read-write, admin.
Use the set port static-vlan command to assign static VLANs to ports.
The syntax for this command is:
set port static-vlan [module/port range] [vlan num]
module Number of the module (3-6). If you do not specify a number,
the ports on all the modules are shown.
port Number of the port on the module. If you do not specify a
number, all the ports on the module are shown.
You can also specify a range of ports separated by a dash, for
example, 4/5-13 for ports 5 to 13 on module 4.
P460-1# set port speed 4/1 100MB
Port 4/1 speed set to 100 Mbps.
module/port
range
Port range
vlan range vlan to bind to port