Filter
Top Products
Chapter 2 Avaya P460 CLI Commands
Avaya P460 Reference Guide 103
set ppp incoming timeout
User level: read-write, admin.
Use the set ppp incoming timeout command to set the number of minutes
until the system automatically disconnects an idle PPP incoming session.
The syntax for this command is:
set ppp incoming timeout <time>
Example:
set qos dscp-agg-index
User level: read-write, admin.
L You can only access this command in Configure mode.
Type configure at the command prompt to enter Configure mode if
necessary.
Use the set qos dscp-agg-index command to configure the DSCP aggregate
index.
The syntax for this command is:
set qos dscp-agg-index <dscp> <agg-index>
Example:
set qos dscp-cos-map
User level: read-write, admin.
L You can only access this command in Configure mode.
Type configure at the command prompt to enter Configure mode if
time The timeout in minutes
P460-1# set ppp incoming timeout 15
PPP incoming session will automatically disconnect after 15
minutes of idle time
dscp1 dscp entry (0-63)
agg-index aggregate index 0-63
Router-1(configure)# set qos dscp-agg-index 5 3