Filter
Top Products
Chapter 2 Avaya P460 CLI Commands
108 Avaya P460 Reference Guide
Normally, the UDP port number should be set to its default value of 1812. Some
early implementations of the RADIUS server used port number 1645.
The syntax for this command is:
set radius authentication udp-port <number>
Example:
set slot power
User level: read-write, admin.
Use the set slot power command to power up or power down a slot. If there is
a module in the slot, then the command will reset the device.
The syntax for this command is:
set slot power [Mod {Up|Down}]
Example 1 – if the slot is empty:
P460-1(super)# set radius authentication udp-port number
1645
Mod Module number
Up Power up the module
Down Power down the module
P460-1> set slot power 4 up
slot 4 power is enabled
P460-1> set slot power 4 down
slot 4 power is disabled