Filter
Top Products
Chapter 2 Avaya P460 CLI Commands
54 Avaya P460 Reference Guide
or
ip vlan name <vlan-Name>
Example:
To specify VLAN developmental as the VLAN used by interface “products”:
If you wish to define a name which includes spaces, you must enclose the entire
name in quotation marks, for example “new york”.
ip vrrp
User level: read-write, admin.
L You can only access this command in Interface mode.
Type interface [name] at the command prompt to enter Interface mode if
necessary.
Use the ip vrrp command to create a virtual router on the interface.
Use the no ip vrrp command to delete a virtual router.
The syntax for this command is:
[no] ip vrrp <vr-id>
Example:
ip vrrp address
User level: read-write, admin.
L You can only access this command in Interface mode.
Type interface [name] at the command prompt to enter Interface mode if
necessary.
Use the ip vrrp address command to assign an IP address to the virtual
router.
Use the no ip vrrp address command to remove an IP address from a virtual
router.
Router-1(config-if:marketing)# ip vlan name development
vr-id Virtual Router ID (1-255)
Router-1(configure-if:marketing) # ip vrrp 1
Done!