Filter
Top Products
Chapter 2 Avaya P460 CLI Commands
Avaya P460 Reference Guide 99
Example:
set port trap
User level: read-write, admin.
Use the set port trap command to enable or disable generic SNMP uplink or
downlink traps from a port.
The syntax for this command is:
set port trap <module>/<port> {enable|disable}
Example:
set port vlan
User level: read-write, admin.
Use the set port vlan command to set the port VLAN ID (PVID). If adding a
new VLAN, the VLAN number must be within the range.
L You need to define a vlan before setting a port VLAN ID.
P460-1# set port static-vlan 3/4-6 2
VLAN 2 is bound to port 3/4
VLAN 2 is bound to port 3/5
VLAN 2 is bound to port 3/6
module Number of the module (3-6). If you do not specify a number,
the ports on all the modules are shown.
port Number of the port on the module. If you do not specify a
number, all the ports on the module are shown.
You can also specify a range of ports separated by a dash, for
example, 4/5-13 for ports 5 to 13 on module 4.
enable Enable uplink/downlink traps
disable Disable uplink/downlink traps
P460-1# set port trap 3/2 enable
Port 3/2 up/down trap enabled.