Filter
Top Products
Chapter 2 Avaya P460 CLI Commands
Avaya P460 Reference Guide 157
show outband
User level: read-only, read-write, admin.
Use the show outband command to displays the Ethernet Console port status.
This command applies to the specific supervisor module where you execute it.
The syntax for this command is:
show outband
Example:
show port
User level: read-only, read-write, admin.
Use the show port command to display port status on I/O modules.
The syntax for this command is:
show port [<module>[/port]]
Example: to display the status for port 4 on switch 3
P460-1> show outband
Status: Connected
Auto-negotiation: Enable
Duplex: Half-Duplex
Speed: 100 MBit/sec
module
(Optional)
Number of the module (3-6). If you do not specify a number,
the ports on all the modules are shown.
port
(Optional)
Number of the port on the module. If you do not specify a
number, all the ports on the module are shown.
You can also specify a range of ports separated by a dash, for
example, 4/5-13 for ports 5 to 13 on module 4.
P460-1> show port 3/4
Port Name Status Vlan Level Neg Dup. Spd. Type
------ --------------- --------- ---- ------ ------- ---- ---- -----------------
3/4 NO NAME no link 1 0 enable half 10M 10/100BaseTx Port