Filter
Top Products
Setting Up
Chapter 2 Setting Up 2-41
LASER CLASS 3170 Series.
CFYA/YAH/YAN 120v US V1.0
Turning on the Power
1.
Connect the power cord to the power socket on the rear of the fax
unit.
2.
Connect the other end of the power cord to the power source.
THE FAX MUST BE CONNECTED TO A PROPERLY GROUNDED,
THREE-PRONG 120 V AC OUTLET.
After you connect the power cord to the power source, the fax
LCD display will light. There is no power switch on the fax unit.
It will take a few seconds for the unit to warm up.
PLEASE WAIT
The unit has warmed up and is ready to use when you see the
date and time display.
12/31/1999 FRI 12:20
When the date is displayed on the LCD, the fax is in the standby
mode and ready for normal operation. If the Error lamp starts
blinking red, wait for one of the following messages to appear.