Filter
Top Products
5
28
SENDING DOCUMENTS
Preparing to send a document
Before you send a document, see Chapter 3: DOCUMENTS AND PAPER.
Adjusting the quality of your documents
■ Setting the scanning resolution
Resolution is a measure of the fineness or clarity of a printout. Low resolutions may cause text and graphics to have a
jagged appearance, while higher resolutions provide smoother curves and lines, crisp text and graphics, and a better
match to traditional typeface designs.
■ Setting the scanning contrast
Contrast is the difference in brightness between the lightest and darkest parts of a printed document. You can adjust
the contrast your fax uses to send or copy documents, according to how light or dark your document is.
The higher the resolution, the higher the output quality, but the slower the scanning speed.
1 Load the document face down into the document feeder (see p. 13).
2 Press [Resolution] to select the resolution.
• You can select <STANDARD>, <FINE>, <PHOTO> or <SUPERFINE>.
• After about 5 seconds, the fax returns to standby mode.
• The documents are transmitted with the <FINE> resolution when <SUPERFINE> is selected. <SUPERFINE> is effective only
when copying.
You can change the resolution setting while the document is being scanned for sending. However, please note that your
new setting will only be effective from the next page scanned.
1 Press [Function], then press [Start/Copy] twice.
2 Use [ ] or [ ] to select <SCAN CONTRAST>, then press [Start/Copy].
3 Use [ ] or [ ] to adjust the scanning contrast, then press [Start/Copy].
You can select <STANDARD>, <DARKER> or< LIGHTER>.
4 Press [Stop].
Setting ends and the fax returns to standby mode.
STANDARD
Thalia.book Page 28 Tuesday, September 28, 2004 10:13 AM