Filter
Top Products
8
Connecting the AC power cord
Plug the fax into a 200–240 volt AC 50/60 Hz outlet.
Setting the language and country
You need to select the correct language for the LCD display and reports, and the country* of use. See pp. 16, 17 for
the buttons on the operation panel.
* This setting is only available for some countries.
Setting the date and time
The date and time appear on the LCD as well as on the documents you send. See pp. 16, 17 for the buttons on the
operation panel.
1 Plug the power cord connector into the rear of the fax.
2 Plug the other end of the power cord into a properly grounded AC power outlet.
There is no power switch on the fax. The power is on as long as the fax is plugged in.
1 Press [Start/Copy] after the display shows <DISPLAY LANGUAGE>.
2 Use [ ] or [ ] to select the preferred language for the LCD display and reports, then press [Start/Copy].
Wait a second for <COUNTRY SELECT>* to appear, then press [Start/Copy].
3 Use [ ] or [ ] to select the country where you are using the fax*, then press [Start/Copy].
Registration ends and the fax enters standby mode.
1 Press [Start/Copy] after the display shows <DATE & TIME>.
2 Use the numeric buttons to enter the date and time using the day-month-year format (DD/MM YYYY), then
press [Start/Copy].
• Set the time using 24-hour clock system. Precede single digits with a zero.
Example: 3:00 p.m.=15:00
• To change the date format, see SYSTEM SETTINGS, P.43.
01/01 2004 00:00
Thalia.book Page 8 Tuesday, September 28, 2004 10:13 AM