Filter
Top Products
Projector WUX10 MarkII User Commands
- 79 -
Revision Histor
y
/ Date Chan
g
es Revised b
y
A
pp
roved b
y
ZCONTDRV
Zoom lens continuous drive control
Format
ZCONTDRV=<Zoom lens continuous control parameter:ID>
<Zoom lens continuous control parameter:ID>
STOP This stops the zooming.
WIDE This zooms to the wide-angle end.
TELE This zooms to the telephoto end.
Environment
Power Input
OFF ON PM D-RGB A-RGB1 A-RGB2 COMP VIDEO HDMI None
X O X -
Response
"i:OK" is returned when the drive was completed successfully.
For details on other responses, refer to the "Error List".
Description
(1) This command is used to drive the zoom lens continuously.
(2) This command functions in the same way as when first the "ZOOM" button on the remote
control or main unit panel is pressed and then the "↑" or "↓" button is pressed.
(3) Zoom drive is started by specifying "TELE" or "WIDE".
To stop the drive, send the "ZCONTDRV=STOP" command.
If no instruction was given to stop the drive, the drive stops at the drive direction end.
(4) The following commands are acknowledged during zoom drive, but zoom drive will also stop at
the same time.
a. POWER
b. ZCONTDRV=STOP
(5) The following commands are acknowledged during zoom drive, and a response is returned
while the drive continues.
a. GET MODE e. GET PRODCODE i. LOCAL
b. GET POWER f. GET ROMVER j. RC
c. GET ERR g. GET COMVER k. MAIN
d. GET LAMPCOUNTER h. REMOTE l. [NULL]
(6) There are no GET commands available for this command.
Example
Control
> ZCONTDRV=TELE Control over the zooming to the telephoto end is started.
< I:OK
* Commands are indicated by ">", and responses are indicated by "<".