Casio KL-7000 Label Maker User Manual


 
9
Part 2
Getting Ready
This part of the manual tells you how to load batteries and the tape cartridge, and how to
perform other basic setups for the Label Printer.
Important!
Be sure to read this section before attempting to use the Label Printer.
Power Supply
The Label Printer can be powered by eight AA-size batteries or an optional AC adaptor
(AD-A95100). A CR2032 battery is also used as a memory back-up power supply.
Replacing Batteries
A handy low battery power indicator lets you know when battery power is getting too low for
proper operation. The message LOW BATTERY appears on the display if battery power is
low when you perform any of the following operations.
Switching power on
Executing a print operation
Executing a tape feed operation
When the LOW BATTERY message appears, press ESC to clear it from the display. You
should still be able to perform some Label Printer operations, but some power intensive
operations (like printing or tape feed) may become impossible if battery power is too low. In
any case, you should replace batteries as soon as possible or switch to the AC adaptor as
soon as possible after the LOW BATTERY message appears.
Important!
Batteries can burst or leak and damage your unit if you use them the wrong way. Note the
following important points.
Be sure that the plus (+) and minus () sides of each battery are facing correctly.
Never mix batteries of different types
Never leave dead batteries in the battery compartment.
Remove the batteries if you do not plan to use the unit for a long time.
Be sure to replace the main battery in accordance with the battery life noted on the side
of the battery itselt, and the back-up battery once every 1 year.
Warning!
Never recharge the batteries you use with this unit.
Do not expose batteries to direct heat, do not short circuit them, and do not try to take
them apart.
Keep batteries out of the reach of small children. If swallowed, consult with a
physician immediately.
Low battery power is indicated by poor print quality or power switching off while printing
is in progress.