Casio KL-7000 Label Maker User Manual


 
15
2. Press SET UP to display the setup menu.
3. Use K and L to highlight WIDTH, and then press
SET.
4. Use K and L to select 6mm (to specify 6mm wide tape) or OTHER (to specify an-
other width), and then press SET.
Display Contrast
Rotate the dial on the side of the Label Printer to adjust display contrast.
Sound Effects
The Label Printer is equipped with sound effects that sound when you switch power on and
when an illegal operation is attempted. Normally, sound effects are switched on whenever
you switch power on, but you can use the following procedure to cancel the sound effects.
To cancel sound effects when switching power on
Hold down the ESC key, switch power on.
Sound effects remain switched off until you switch them back on again (using the proce-
dure described below), or until you switch power off and then on again.
Use the following procedure to switch sound effects on and off.
To switch sound effects on and off
1. Switch power on.
2. Press SET UP to display the setup menu.
3. Use K and L to highlight SOUND, and then press
SET.
FUNC
SHIFT
CODE
VERT
MIROR
OVER
CAPS
A
A
SET
Yes No
ESC
INPUT
DENSITY
SOUND
WIDTH
FUNC
SHIFT
CODE
VERT
MIROR
OVER
CAPS
A
A
SET
Yes No
ESC
WIDTH
6mm
OTHER
FUNC
SHIFT
CODE
VERT
MIROR
OVER
CAPS
A
A
SET
Yes No
ESC
INPUT
DENSITY
SOUND
WIDTH
FUNC
SHIFT
CODE
VERT
MIROR
OVER
CAPS
A
A
SET
Yes No
ESC
SOUND
ON
OFF