Filter
Top Products
12
3. Press SET to initialize the Label Printer or ESC to abort the operation without initializing
anything.
• If you press SET, the initial reset screen appears.
• See “Initial Settings” for the initial default settings of the Label Printer following the reset
operation.
Power On Recall Function
Whenever you switch your Label Printer off, it stores the text that is currently on the display.
Immediately after you switch power on, you can recall the last text displayed by pressing
SET.
Important!
You can recall text by pressing SET when the text input display is clear, immediately after
switching power on only. Even if you input text and then delete it, pressing SET will not
recall stored text.
Auto Power Off Function
If you do not perform any key operation for about six minutes, the Label Printer automati-
cally switches power off. To restore power, press ON.
• After you restore power, you can recall the last text that you displayed by pressing SET.
See “Power On Recall Function” for details.
Tape Cartridges
Use the procedures described below to load tape cartridge into the Label Printer. After you
load the tape cartridge, be sure to use the procedure described under “To specify the tape
width” to tell the Label Printer what width of tape you are using.
Important!
• Never try to push the tape back into the cassette. Once tape is out of the cassette, there
is no way to wind it back in. Trying to do so can cause operational problems with the
Label Printer.
• Always make sure that Label Printer power is switched off before you replace the tape
cartridge.
To load a tape cartridge
1. Make sure that the power of the Label Printer is switched off.
2. Press the tape cartridge compartment cover
release and open the compartment cover.
• If there is a cartridge already installed in the
unit, remove it by grasping the tape cartridge
on both sides with your thumb and forefin-
ger and lifting it straight up.