Filter
Top Products
Section 3: Operation
RPMX/CX50/CX60/CX67 User’s Manual 3-17
White Boost
This option allows you to recapture some of the lost light from the transition
between segments in the color wheel when it is spinning. Use the slidebar to
increase the value of White Boost from 0 to 10. When set to a value of “0” the
option is OFF. As you increase the value, you will notice the image becomes
slightly brighter and a little less saturated.
NOTE: It is recommended Auto Setup and Auto Input Levels be adjusted prior
to applying White Boost for new sources. 2) For NTSC, HDTV, PAL and SECAM
video and graphics signals the default is set to “10”. 3) White Boost is disabled
when an internal test pattern is displayed – the option appears in yellow text. 4)
It is recommended White Boost remain at 0 when adjusting input levels.
From this menu, you can select an input instead of using the direct keys on the
keypad. You can also view the settings of the current incoming signal.
Figure 3.17. Input Setup Menu
Input Select
Use Input Select to select from a list of available input signals that can be
displayed by the projector. (Figure 3.18.) Highlight the option and press
Enter
, to
select an input. NOTE: You can make the same selection using the “direct” keys
on the keypad.
Figure 3.18. Selecting an Input
Mode Memory Status
This read only window displays the current information on the incoming signal,
such as source, resolution and horizontal and vertical frequencies (Figure 3.19.)
Figure 3.19. Mode Memory Status
In
p
ut Setu
p
'